facebook instagram Whatsapp
Certified Master Roofers in Metro Vancouver

No worries. Let's try it this way

Please fill your details, and we will provide you with an estimate in a very timely manner.

Two roofers working on the grey asphalt shingle roof of a two-storey house, with the Vancouver skyline and North Shore mountains behind.

Roofing in Vancouver, BC

Vancouver roofs work through long winter rain, deep shade and heavy tree cover, on lots where access often shapes a job before anything else does. Drainage, flashing and ventilation decide how well a roof holds up here.

GoodVans Roofing works on houses, character homes, laneway buildings, strata complexes and low-slope commercial properties across Vancouver — repairs, replacements, inspections and maintenance.

Why local conditions matter

Rain and shade are the obvious pressures. The less obvious one is the building itself. Vancouver's housing has been added to in layers, and a single property often carries more than one roof.

A steep pitched roof over the main house, a low-slope section over a rear addition or carport, a garage or laneway building at the back — three surfaces, three systems, three different ways to fail. Scoping a roof in this city usually means pricing more than one of them.

Lot width and access count for as much. On a standard city lot with a narrow side yard and lane-only access, where material lands and where waste leaves are planning questions before they are pricing ones.

Older housing adds a third factor. Attics built before current ventilation practice often cannot move air the way the covering above them assumes, and a tear-off is the moment to correct that rather than re-roof over it.

Rain-soaked asphalt shingles above a metal gutter and downspout on a house, with wet evergreen trees beyond.

What does a roof replacement cost in Vancouver?

There is no flat rate. A roof is priced from what can be measured — its size and shape, what sits beneath the covering, what goes back on, and how the site works — so a reliable figure only follows an inspection of the roof and attic, set out in a written estimate.

Compare estimates on scope rather than totals: materials, underlayment, flashing, ventilation, disposal and a stated allowance for decking repair. Two numbers without that breakdown rarely describe the same job.

The variables that move it, roughly in order of weight

  1. Roof area and pitchMeasured on the roof plane, not the floor plan, and steeper work carries fall-protection cost.
  2. Layers to removeEach existing layer adds removal, handling and disposal.
  3. Decking conditionThe usual reason a final invoice differs from the quote. Ask for the per-sheet rate on replacement sheathing up front.
  4. MaterialThe largest single lever once size is fixed.
  5. Detail workValleys, dormers, skylights, chimneys and parapets. Flashing is where most roofs leak, and detail is where the labour goes.
  6. Access and stagingLane-only access, no driveway, or a street that has to be occupied all change the method and the schedule.

Do you need a permit to replace a roof in Vancouver?

Check your specific scope before work starts.

Vancouver regulates construction under its own Building By-law, made under the Vancouver Charter rather than applying the provincial code directly — the current edition took effect on 15 September 2025 and adopts the 2024 BC Building Code with Vancouver provisions added.

The City's building permit guidance (opens in a new tab) does not address re-roofing either way. It names new construction, additions, interior wall changes and changes of use as work requiring a permit, publishes no list of exempt work, and asks owners to contact the Development and Building Services Centre where a project is unclear. Scope decides it, not the word "roof".

Work that changes the structure or the roof line — new framing, a dormer, a raised or altered roof — sits among the categories the City does name.

If roofing work needs to occupy a street, sidewalk or rear lane, a separate City street-use or temporary occupancy permit may also be required.

Roofing by property type

Roofers installing asphalt shingles on a house roof, with a ladder at the eave and mountains in the distance.

Vancouver's detached stock runs from pre-war character homes through post-war bungalows to recent infill, often with a garage or laneway building sharing the lot. Residential roofing in Vancouver covers repair, replacement, flashing, gutters, vents and skylights across those forms — including the common case where the house and the structure behind it are on separate replacement clocks.

Roofers applying a torch-on membrane on a flat commercial roof beside rooftop mechanical units, with city towers behind.

Many commercial and light-industrial buildings use low-slope roofing, including through Mount Pleasant, the False Creek Flats and the Broadway corridor, and low slope fails differently: water is drained rather than shed, so blocked drains, ponding and seam failure generally arrive well before the membrane wears out. Commercial and industrial roofing in Vancouver covers inspection, repair, membrane replacement, coatings and planned asset management.

Roofers working on the shingle roofs of a row of attached strata townhomes, with a ladder against the building.

Vancouver's low-rise and mid-rise strata buildings often combine steep asphalt over the units with low-slope areas over walkways, decks and parkade entries — two systems, two lifespans, one budget. Strata and multi-family roofing in Vancouver covers condition assessment, scheduled work and the reporting a council needs. Approval runs through the council and, depending on the bylaws and the expenditure, an owner vote.

Roofing materials compared

Metal offers one of the longest potential service lives among the systems below and gives moss nothing to grip. Architectural asphalt stays the common choice on Vancouver houses because it balances cost, appearance and service life. The ranges below are general industry figures; what a roof actually reaches depends on installation, ventilation and upkeep.

Material Typical service life (approx.)Commonly used forMaintenanceNotes for Vancouver
Architectural asphalt 20–30 years Houses, townhouses, strata Moderate Standard across the city's detached stock. Algae-resistant lines are worth specifying where tree cover keeps a slope damp.
Metal and metal shingles 40–70 years Infill, modern builds, exposed upper storeys Low Clears heavy rain quickly and gives moss no foothold. Highest upfront cost.
Cedar shake 20–30 years Character and heritage homes High Suits the look of older Vancouver streets, but needs consistent upkeep in shade and damp.
Torch-on SBS 20–30 years Low-slope sections, commercial, flat additions Moderate Common on flat areas and rear additions. Drainage has to work — standing water is a fault to correct, not a condition to design around.

Roof repair or replacement?

Repair

Fits damage that is contained — a single leak, one wind-damaged slope, one flashing detail that has failed, with the rest of the roof sound.

Replacement

Fits wear that has spread: deck damage in more than one place, repeat call-outs in a single season, or a running repair cost closing on the cost of replacing.

Ventilation correction

A sound covering over an attic that cannot breathe needs the ventilation corrected, not a new roof.

Moss, moisture and drainage

Mature street trees and narrow side yards keep parts of a Vancouver roof shaded through most of the winter, and a shaded slope stays wet long enough for moss to establish. Moss holds water against the covering, works under shingle edges as it thickens and keeps the surface damp — which shortens the life of any material.

  • Deal with it while it is still thin.

  • Do not pressure wash an asphalt roof: the force strips granules and takes service life off the shingle. Soft-wash or manufacturer-approved treatments are the safer route.

  • On the flat sections of a Vancouver property the equivalent task is drainage — keep drains, scuppers and gutters clear, and treat standing water as something to investigate.

Moss growing along the lower edge of a shingle roof, with wet leaves collected in the gutter below.

Roof inspection and replacement process

What it covers
An inspection covers flashing at every penetration, the condition of the covering and its granules, gutters and valleys, moss coverage, attic ventilation and the underside of the deck, and provides a clear summary of what was found and recommendations for what should happen next.
Attic inspection
The attic often shows what the surface does not — moisture, frost, or air that is not moving as it should.
How often

Once a year suits most roofs, ideally in early autumn so anything found can be handled before the wet months.

Twice a year is sensible past fifteen years, under heavy tree cover, or with a history of moss — and after a windstorm, or ahead of a sale.

Book a roof inspection in Vancouver — a clear summary of what was found, and a straight answer on repair versus replacement.

Roofer in a hard hat and safety harness kneeling on a shingle roof, checking the shingles with a clipboard in hand.

Replacement process

A typical replacement sequence is:

  1. Written estimate

  2. Material selection

  3. Scheduling with a weather allowance

  4. Site protection and tear-off

  5. Deck repair and underlayment

  6. Installation with ventilation completed as a designed pair

  7. Final inspection

  8. Nail sweep

  9. Site clean-up

Roof maintenance calendar for Vancouver

Autumn, before the heavy rain

  • Clear gutters, downspouts, valleys and flat-roof drains
  • Cut branches back off the covering
  • Check sealant at chimneys, vents and skylights

End of winter

  • Treat moss on shaded slopes
  • Clear gutters again
  • Check the attic for damp insulation or frost on the deck

After a windstorm

  • Look over the ground for shingle pieces and granule wash

For material-by-material guidance, see roof life expectancy and maintenance.

Roofing warranties: what is actually covered

Two separate warranties can apply to one roof: a manufacturer's product warranty and a contractor's workmanship warranty. They cover different things, for different periods, on different conditions, so ask which applies to your installation.

Manufacturer's product warranty

Coverage for eligible roofing materials is subject to the manufacturer's warranty terms, conditions and product-specific requirements.

Contractor's workmanship warranty

Coverage for eligible installation-related workmanship is subject to the agreed roofing contract and its applicable warranty terms.

Worth asking of any contractor:

  • whether the job is registered with the manufacturer
  • whether cover transfers if you sell
  • what conditions attach. Ventilation requirements are a common one.

Frequently asked questions

How much does a roof replacement cost in Vancouver?

There is no reliable flat rate. Cost depends on roof area and pitch, the material, how many layers come off, the state of the decking, flashing and detail work, ventilation, disposal and site access. An accurate figure follows an inspection, set out as a written estimate.

Do I need a permit to replace a roof in Vancouver?

The City's guidance does not address re-roofing either way, so confirm your own scope first. Work that changes the structure or the roof line falls among the categories the City does name, and work occupying a street, sidewalk or rear lane may need a separate street-use permit. The Development and Building Services Centre confirms what a project needs.

My house has a pitched roof and a flat section — are they replaced at the same time?

Not necessarily. They are separate systems with separate lifespans, and one can have years left when the other does not. An inspection gives a condition for each, so you can replace both in one mobilisation or stage them deliberately rather than finding the second mid-project.

When is the best time of year to replace a roof in Vancouver?

Late spring through early autumn is the easiest window: consecutive dry days let sealants cure and shingles seal down as designed. Work can be carried out outside it, but on a lane-access site, or one occupying a street, the drier months make scheduling considerably simpler.

Talk to a roofing specialist about your Vancouver property

Tell us what you are seeing and we will say whether it needs a visit. If it does, you get a clear summary of what was found and an itemised estimate before anything is booked.

Roofing in nearby Metro Vancouver communities

GoodVans Roofing also works in Burnaby, Richmond, North Vancouver and New Westminster.

Let's talk

Contact Info

  • Address GoodVans Roofing 207 W Hastings St, Unit 1210, Vancouver, BC V6B 1H7, Canada
  • Contact Number 17783778209
  • Email ID info@gvroofs.ca
facebook instagram Whatsapp